Author: Martinello, M.
Paper Title Page
MOPA21 Effect of Electropolishing on Nitrogen Doped and Undoped Niobium Surfaces 93
  • V. Chouhan, F. Furuta, M. Martinello, T.J. Ring, G. Wu
    Fermilab, Batavia, Illinois, USA
  Cold electropolishing (EP) of a nitrogen-doped (N-doped) niobium (Nb) superconducting RF (SRF) cavity was found to improve its quality factor. In order to understand the effect of EP temperature on N-doped and undoped surfaces, a systematic EP study was conducted with 2/0 N-doped and heat-treated Nb samples in a beaker. The Nb samples were electropolished at different surface temperatures ranging from 0 to 42 C. The results showed that the doped surface was susceptible to the sample temperature during EP. EP resulted in the surface pitting on the doped samples where the number density of pits increased at a higher temperature. The surface results were compared with the surface of cutouts from a 9-cell cavity which was 2/0 N-doped and electropolished. This paper shows de-tailed surface features of the N-doped and undoped Nb surfaces electropolished at different temperatures.  
DOI • reference for this paper ※ doi:10.18429/JACoW-NAPAC2022-MOPA21  
About • Received ※ 20 July 2022 — Revised ※ 24 July 2022 — Accepted ※ 09 August 2022 — Issue date ※ 11 August 2022
Cite • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
MOPA22 Study on Electropolishing Conditions for 650 MHz Niobium SRF Cavity 97
  • V. Chouhan, D.J. Bice, F. Furuta, M. Martinello, M.K. Ng, H. Park, T.J. Ring, G. Wu
    Fermilab, Batavia, Illinois, USA
  • B.M. Guilfoyle, M.P. Kelly, T. Reid
    ANL, Lemont, Illinois, USA
  The PIP II linear accelerator includes different types of niobium SRF cavities including 650 MHz elliptical low (0.61) and high (0.92) beta cavities. The elliptical cavity surface is processed with the electropolishing method. The elliptical cavities especially the low-beta 650 MHz cavities showed a rough equator surface after the EP was performed with the standard EP conditions. This work was focused to study the effect of different EP parameters, including cathode surface area, temperature and voltage, and optimize them to improve the cavity surface.  
DOI • reference for this paper ※ doi:10.18429/JACoW-NAPAC2022-MOPA22  
About • Received ※ 02 August 2022 — Revised ※ 09 August 2022 — Accepted ※ 11 August 2022 — Issue date ※ 03 September 2022
Cite • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)